Measurement of laminated safety glass thickness must follow ISI procedure for nominal thickness and duty classification. Thickness of laminated safety glass must be measured per IS : 2553 Part I : 1990 applying the method in para 5.1 and Annexure B of IS : 2835-1987 using screw calipers (0.01 mm accuracy) at four specified points; individual readings must fall within the nominal ranges set out in the ISI table. Nominal thickness is determined from the table; purchaser supplier agreed alternate nominals use the range of the immediately lower listed thickness. The same method applies to toughened safety glass.
Cases where this provision is explicitly mentioned in the judgment/order text; may not be exhaustive. To view the complete list of cases mentioning this section, Click here.
Provisions expressly mentioned in the judgment/order text.
Measurement of laminated safety glass thickness must follow ISI procedure for nominal thickness and duty classification.
Thickness of laminated safety glass must be measured per IS : 2553 Part I : 1990 applying the method in para 5.1 and Annexure B of IS : 2835-1987 using screw calipers (0.01 mm accuracy) at four specified points; individual readings must fall within the nominal ranges set out in the ISI table. Nominal thickness is determined from the table; purchaser supplier agreed alternate nominals use the range of the immediately lower listed thickness. The same method applies to toughened safety glass.
Full Summary is available for active users!
Note: It is a system-generated summary and is for quick reference only.
TaxTMI 
of 
Join Channel
TaxTMI 
