Aluminium profile classification remains under the specific heading when cut lengths retain uniform cross-section and profile characteristics at import.
Aluminium hollow profiles retain classification under the specific tariff heading for aluminium profiles where their objective characteristics, including uniform cross-section, remain intact at import. Cutting profiles to length, invoice descriptions, prior self-assessment and intended use in solar modules do not by themselves convert them into finished articles or justify classification under a residuary heading. Concessional customs treatment for Chapter 76 goods used to manufacture notified Solar PV Modules depends on the prescribed end-use procedure and valid end-use certificates, rather than possible alternative uses or precise classification within that Chapter. The stated amendment applies prospectively from 1 April 2022; concessional treatment remains available for earlier Bills of Entry meeting the conditions.
Issues: (i) Whether the imported cut-length aluminium hollow profiles were classifiable under CTI 76042100 or under residual CTH 76169990; (ii) Whether exemption under Serial No. 39 of Notification No. 24/2005-Cus was available for goods used in manufacture of Solar PV Modules.
Issue (i): Whether the imported cut-length aluminium hollow profiles were classifiable under CTI 76042100 or under residual CTH 76169990.
Analysis: Classification must be determined from the objective characteristics and condition of goods when presented for assessment, applying the tariff terms, relevant notes and interpretative rules. Invoice nomenclature, past self-assessments and intended downstream use are not conclusive. Section Note 9(b) treats products of uniform cross-section as profiles even where subsequently worked, unless they assume the character of articles of another heading. Cutting profiles into shorter lengths does not, by itself, cause them to cease being profiles. No evidence established that the imported goods had lost their profile characteristics, lacked uniform cross-section, or had become finished, independently usable frames. Heading 7604 specifically covers aluminium profiles, whereas Heading 7616 is residuary and cannot displace a specific heading merely because the goods were described as solar frames or intended for use in solar modules.
Conclusion: The imported goods are classifiable under CTI 76042100 as aluminium hollow profiles, in favour of the assessee.
Issue (ii): Whether exemption under Serial No. 39 of Notification No. 24/2005-Cus was available for goods used in manufacture of Solar PV Modules.
Analysis: The exemption turns on the intended manufacture of the notified final goods and compliance with the concessional-duty procedure, not on hypothetical alternate uses of the imported goods. The prescribed procedure was followed and end-use certificates issued by the jurisdictional authorities were furnished; their validity was neither disputed nor shown to have been obtained improperly. The exemption was available to Chapter 76 goods used for manufacture of the specified Solar PV Modules irrespective of their precise classification within that Chapter. The subsequent amendment operated from 01.04.2022.
Conclusion: The exemption is admissible for Bills of Entry filed on or before 31.03.2022, in favour of the assessee.
Final Conclusion: The reclassification and denial of concessional treatment fail; consequently, the duty demand does not survive and no interest, redemption fine or penalty can be sustained.
Ratio Decidendi: Goods that retain the objective character of aluminium profiles at import remain under the specific profile heading despite cutting to length or intended downstream use, and cannot be shifted to a residuary heading without evidence that they have assumed the character of finished articles.