Exemption to specified goods imported for manufacture of specified goods

X X   X X   Extracts   X X   X X

Full Text of the Document

X X   X X   Extracts   X X   X X

.... the said Table, when imported into India for the purpose of manufacture of the goods specified in the corresponding entry in column (4) of the said Table, from - (a) so much of that portion of the duty of customs leviable thereon which is specified in the said First Schedule, as is in excess of the amount calculated at the rate of forty-five per cent ad valorem; and (b) the whole of the additional duty leviable thereon under section 3 of the said Customs Tariff Act. subject to the following conditions, namely :- (i) an officer not below the rank of a Joint Director in the Department of Electronics of the Government of India or a Joint Director in the Directorate of Industries of the Government of a State or an Additional Industria....

X X   X X   Extracts   X X   X X

Full Text of the Document

X X   X X   Extracts   X X   X X

.... of Transmitting Tubes Transmitting Tubes 6. 84, 85 (i) Ferrite Permanent Magnets DC Micromotors of voltage rating upto 13.5 volts and not exceeding 20 watts rating     (ii) Sintered/self lubricating Bushes     (iii) Screws, Gears, collectors, Brush holders 7. 85 Parts of Cathode Ray Tubes Cathode Ray tubes 8. 38, 85 Silicon in the form of Diffused or undiffused wafers, discs or chips Semiconductor Devices 9. 69, 78, 85 (i) Headers Semiconductor Devices, Resistors (other than Heating Resistors) Capacitors, connectors Hybrid Microcircuits, Printed components. (ii) Caps with or without leads (iii) Cans with or without leads (iv)....

X X   X X   Extracts   X X   X X

Full Text of the Document

X X   X X   Extracts   X X   X X

....ray Tubes X-ray Tubes     (ii) HT Cables 21. 84, 85 Parts of Vacuum Interru ptor Tubes Vacuum Interruptor Tubes 22. 39 Ferromagnetic coated polyethylene Terephthalate Film in form of punched Coppies Floppy Diskettes 23. 38, 73 Precalcined/Pre-sintered Ferrite Powder Ferrites 24. 39, 74, 75 (i) Composite copper clad materials consisting of Paper + Epoxy + Glass Cloth Printed Circuit Boards     (ii) Copper Clad Laminates Laminated to Nylon, Teflon, Polyester     (iii) Aluminium clad Entry foil and back-up laminates 25. 39, 85 (i) Polyolefins Tubes Delay Lines     (ii) Terminals   ....

X X   X X   Extracts   X X   X X

Full Text of the Document

X X   X X   Extracts   X X   X X

....; (iii) Graphite Foil or 0.5 mm thick       (iv) Boron nitride Paint   30. 85 (i) Formers, Bases, Bobbins RF/IF Coils or Transformers     (ii) Holders, Brackets       (iii) Shielding Cases, Cans   31. (a) 32, 39, 73, 76, 85 (i) Aluminium Anode & Cathode Tabs Electrolytic Capacitors     (ii) Aluminium Anode & Cathode inserts       (iii) Marking foil       (iv) Moulded covers   (v) Rubber/Bakelite covers or laminates     (vi) Soldered Lugs       (vii) Aluminium Wash....